Maretron

Mini Power Cordset - 2 Power & 2 Ground To Female 1M2 power and 2 ground to female 1 meter Manufacturer : Maretron Manufacturer Part No : NM4P-01 UPC : 873804002422

Mini PowertapA powertap is connected to a network backbone just like any Tee but rather than connecting a device their purpose is to provide "bus" power. Typically a Powertap is placed as central as...

Mini TeeA Tee is used to tap into the trunk line for adding a drop connection. Gold contacts for greatest reliabilityKeyed connectors for error-free connectionsMale (left)Female (Bottom)Female...

Termination Resistors are required on a NMEA 2000 network and are placed at each end of a network trunk cable. Like the double-ended cordsets, the termination resistors are waterproof and continue...

Termination Resistors are required on a NMEA 2000 network and are placed at each end of a network trunk cable. Like the double-ended cordsets, the termination resistors are waterproof and continue...

Mini/Micro TeeA Tee is used to tap into the trunk line for adding a drop connection. A Mini/Micro Tee has Mini connectors for the trunk lines and a Micro connector for the drop line.Gold contacts...

Motion Detector for SIM100Passive Infrared Motion Detector (PIR)Attaches to Maretron SIM100 for NMEA 2000® network monitoringWARNING: This product can expose you to chemicals including NICKEL...

Multiport boxes allow several drop cables to be consolidated and connected back to the trunk, which eliminates the need to have numerous tees connected near a single point. Multiport boxes connect...

Mini Gender ChangersMaretron cables have a male connector on one end and a female connector on the other end. Normally, the male connector points back towards the network power supply, but on some...

Maretron NM-CF Mini Male to Micro Female ReducerThe reducer is used to change from a Mini cable to Micro or Mid cable. For example, one end of the network might be terminated at the top of the mast...

Maretron NM-NM Mini Gender Changer, Male to MaleMaretron cables have a male connector on one end and a female connector on the other end. Normally, the male connector points back towards the network...

NMEA 0183 10 Meter Connection CableA 10 Meter NMEA 0183 connection cable specifically for Maretron's SSC200 & SSC300 Solid State Compasses. Manufacturer : Maretron Manufacturer Part No :...

Network Bus ExtenderPart #: NBE100-01Maretron's NBE100 (Network Bus Extender) allows you to extend the maximum node count, network trunk length and cumulative drop length of any NMEA 2000 network...

NMEA 2000 Starter Kit 1Maretron's deluxe starter kit provides all the necessary cables and connectors necessary to connect two products together on an NMEA 2000® network.   Contacts are...

NMEA 2000 Starter Kit 2 Maretron's deluxe starter kit provides all the necessary cables and connectors necessary to connect two products together on an NMEA 2000® network.   Contacts...

Non-Displacement Hull Focus Tube SAE 5-BoltSAE 5-Bolt non-displacement hull focus tube from Maretron.WARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to...

Pressure Transducer - 0 to 5000 PSIThis pressure transducer is designed to connect to the NMEA 2000® network via a Maretron FPM100 Fluid Pressure Module.Specifications:Range: 0 to 5000 PSI (344...

Pressure Transducer 0 to 1.5 PSIFor use with FPM100 Fluid Pressure MonitorWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to...

Pressure Transducer 0 to 3 PSI - for the FPM100 Fluid Pressure MonitorWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause...

Pressure Transducer 0 to 5 PSI - for FPM100 Fluid Pressure MonitorWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause...

RAA100 NMEA 2000®Rudder Angle AdapterThe RAA100 is used to adapt commercially available resistive rudder angle senders to the NMEA 2000® network. This allows you to observe rudder angle...

RIM100 Run Indicator ModulePart #: RIM100-01Maretron's Run Indicator Module monitors both AC and DC electrical circuits and reports, over an NMEA 2000 network, whether or not the electrical circuit...

SAE 5-Bolt Pattern Focus Tube w/Dead Band EliminatorFocus tubes allow the TLM100/TLM150 ultrasonic tank level monitors to be used for level measurement on vessels with non-displacement hulls at up to...

SIM100 Switch Indicator ModuleMaretron's Switch Indicator Module monitors switch closure devices including, but not limited to, safety equipment (heat, smoke, carbon monoxide, explosive vapor...

Solid-State Rate/Gyro Compass w/10m Cable & ConnectorMaretron's SSC300, implementing the second generation of Maretron's award-wining compass technology, is a solid state, rate gyro electronic...

Solid-State Rate/Gyro Compass without CablesMaretron's SSC300, implementing the second generation of Maretron's award-wining compass technology, is a solid state, rate gyro electronic compass that...

Spare Paddle Wheel KitMaretron spare paddle wheel kitWARNING: This product can expose you to chemicals including NICKEL (METALLIC) which is known to the State of California to cause cancer. For more...

The TR3K temperature probe is for use with the Maretron TMP100 Temperature Module (optional extra) or the DCM100 DC Monitor (it is included with the DCM100). This probe ends in a ring terminal and...

TLA100 NMEA 2000®Tank Level AdapterThe TLA100 is used to adapt commercially available resistive tank senders to the NMEA 2000® network. This allows you to observe tank levels anywhere on the...

The TLM100 is used to sense levels of liquid tanks using ultrasonic technology and transmit the liquid levels over the NMEA 2000 network. This allows you to observe tank levels anywhere on the vessel...

The TLM150 is used to sense levels of gasoline tanks using ultrasonic technology and transmit the gasoline levels over the NMEA 2000 network. This allows you to observe gasoline tank levels anywhere...

Maretron's TMP100 measures the temperature for up to 6 temperature probes and reports the information over an NMEA 2000 network. The TMP100 supports up to 4 thermistor probes and 2 high temperature...

USB100 NMEA 2000® / USB GatewayMaretron's USB100 is a gateway for bridging USB equipment using NMEA 0183 sentences - such as an on-board computer running navigational software - with an NMEA...

Micro Double-Ended Cordset - 0.5M - *Case of 6*MechanicalContact Carrier Mat/Color: Thermoplastic PUR/Blue-GrayMolded Body Mat/Color: Thermoplastic PUR/Blue-GrayContact Mat/Plating:...