Clayton Off Road

The Clayton Off Road Jeep JL/JT Front Axle Disconnect (FAD) Skid Plate for your 2018+ Jeep Wrangler JL or 2020+ Gladiator was designed to offer the maximum protection and strength possible. Our 1/4...

If you want the best control arms on the market with ZERO maintenance, look no further. Overland Plus JT Short Control Arms (8 Adjustable Arms). Over new Overland Plus control arms offer Giiro joints...

Overland Plus JT Short Rear Lower Control Arms (2 Adjustable Arms). Over new Overland Plus control arms offer Giiro joints at both ends of your control arms, while still being fully adjustable. The...

Overland Plus JT Short Rear Upper Control Arms (2 Adjustable Arms). Over new Overland Plus control arms offer Giiro joints at both ends of your control arms, while still being fully adjustable. The...

Jeep Gladiator JT rear bolt in bump stop. Our 3 Inch tall JT rear bump is a direct bolt in and is part of our 2.5 Inch and 3.5 Inch lift kits. Angled design properly lines up upper mount for full...

JT Short Rear Lower Control Arms (2 Adjustable Arms). The Best of the Best. Its not just one thing that puts our arms above the rest. Its our attention to every detail that brings you the safety,...

JT Short Rear Upper Control Arms (2 Adjustable Arms). The Best of the Best. Its not just one thing that puts our arms above the rest. Its our attention to every detail that brings you the safety,...

Our Jeep front spring retainer clips hold the bottom of your front coil spring in place. The spring clips minimize the chance of your coil springs falling out of the vehicle during off-road use...

Our Dual Rate Jeep Wrangler JL coils are both dual rate and side specific. The Jeep Wrangler JL was designed using a passenger and driver specific coils, for optimal balance and height. The Jeep...

Jeep Wrangler JK 2007-2018 Adjustable Front Track Bar  Our NEW JK front adjustable track bar is constructed from 1 3/8" X 5/16" DOM Tubing. Combined with a johnny joint as the adjuster, and a quality...

Jeep Wrangler JK 2007-2018 Adjustable Rear Track Bar  Our JK rear adjustable track bar is constructed from 1 3/8" X 5/16" DOM Tubing. Combined with a johnny joint as the adjuster, and a quality...

Our Jeep Wrangler JL 3 Inch tall rear bump stops are made from 3 Inch x 4 Inch, 3/16 Inch wall rectangular tubing. Pre-drilled, then e-coated for simple bolt in application in your 2018 and up JL...

These are simple yet effective TJ, or LJ rear coil spring retainers. They are sold as a set of 4 with lower hardware. Simply drill and tap the lower coil bucket and sandwich the 4 inch round plate on...

Jeep Wrangler JK 2007-2016Rear Track Bar Relocation Bracket After seeing some other aftermarket trackbars bend or rip the OEM trackbar bracket off the axle, we knew we had to design something that...

Our Jeep Wrangler JL steering stabilizer bracket kit addresses many common issues. This kit includes both raised double sheer axle mount and a new tie rod mount. This is a simple bolt on 3/16s thick,...